發明
中華民國
103102058
I 510684
利用靜電紡絲技術製備之含鈦光觸媒纖維製備方法
國立宜蘭大學
2015/12/01
利用靜電紡絲技術製成二氧化鈦聚丙烯睛纖維材料(Titanium Polyacrylonitrile Nanofibers, TPF),利用二氧化鈦增強纖維膜的比表面積,改善傳統過濾器之效率與壓損,同時二氧化鈦也作為光催化反應的觸媒。本研究亦使用傅立葉紅外線光譜儀(FTIR)、掃描式電子顯微鏡(SEM)、X射線繞射儀(XRD),進行所研製材料特性分析,再進行材料之光催化效率與過濾品質的評估,研究得知VOCs處理最佳操作條件為使用2%TPF,丙酮初始濃度於400 ppm,停留時間50min時,降解效率可達90%以上。由過濾效能測試結果得知,加入二氧化鈦有助於提升濾材的過濾品質,使用2%TPF對微粒過濾之穿透率可低於1.9%。 The particulate filtration performance and VOCs photodegradation were promoted by doping polyacrylonitrile fibers (TPF) with TiO2 nanoparticle. TPF were prepared using the electrospinning method, a simple and effective method. The physical and chemical properties of photocatalysts were indicated with spectrophotometer (UV-vis), X-ray diffractometer (XRD), Fourier-Transform Infrared Spectrometer (FTIR), Scanning Electron Microscope (SEM). This study has been successfully prepared TPF and the optimum TiO2 content fiber is 2% TPF. The degradation efficiency can be up to 90% under the initial acetone concentration of 400 ppm, the residence time of 50 min. The filtration performance results showed that titanium dioxide was added to improve the quality filter filter material. The penetration of 2% TPF could be smaller than1.9 %.
本部(收文號1100059913)同意該校110年9月29日宜大研字第1101051839號函申請終止維護專利(宜蘭大學)
研究發展處
(03)9357-400ext7043
版權所有 © 國家科學及技術委員會 National Science and Technology Council All Rights Reserved.
建議使用IE 11或以上版本瀏覽器,最佳瀏覽解析度為1024x768以上|政府網站資料開放宣告
主辦單位:國家科學及技術委員會 執行單位:台灣經濟研究院 網站維護:台灣經濟研究院